JM Sand Blasting Helmet

Product Description

Key Safety Points for Using Your Blasting Helmet

1. Essential Air Supply:

• Clean Air is Mandatory: This respirator MUST be supplied with clean, breathable air of Grade D or better at all times.
• No Air Purification: The BLASTING HELMET does NOT purify air or filter contaminants.
• Reliable Air Source: Breathable air must be supplied to the point where the safety air supply hose attaches.
• Air Quality Standards: Supplied breathing air must meet the requirements for Type 1 gaseous air as defined by the Compressed Gas Association Commodity Specifications.

2. Breathing Air Pressure:

• Continuous Monitoring: Continuously monitor air pressure at the attachment point while air is flowing to the respirator.
• Accurate Readings: Use a reliable pressure gauge to monitor air pressure while the respirator is in use.

3. Head Harness Adjustment:

• Unclip Pegs: To adjust the head harness, first, unclip the locating pegs.
• Slide Band: Slide the band inwards to reduce the size or outwards to increase it.
• Secure Pegs: Once the desired size is achieved, clip the locating pegs back together.

4. Safe Helmet Removal:

• Exit the Working Area: Always exit the working area BEFORE removing your helmet.
• Reverse Donning Procedures: Follow the reverse steps of the respirator donning procedure.

5. Proper Storage:

• Clean and Inspect: Clean and inspect all respirator components before storage.
• Protect from Damage: Place cleaned components in a plastic bag or airtight container.
• Avoid Harsh Conditions: Store the respirator away from excessive heat, dust, cold, moisture, or harmful chemicals.

Disclaimer: This is a summary of important safety information. Always refer to the full user manual for complete instructions and safety guidelines.

Important Note: This information is for general guidance only and should not be considered professional safety advice. Always consult with a qualified safety professional for specific safety procedures and equipment selection.